Written By
author
Tuesday, September 13, 2022
Edit
+15 Diy Wood Board And Batten Shutters 2022. Make sure they are nice and straight. Diy board and batten shutters.
ShuttersHow to build board board and batten At Home with The Barkers from athomewiththebarkers.com
Paint sticks as spacers and scrap wood as a guide while gluing and nailing the cross pieces on. Diy board and batten shutters. Whenever possible, we try to do our own woodwork to avoid the cost of buying materials and to add a personalized touch to the house.
Two 6″ Pieces Of Scrap Wood Were Used As A Guide To Make Sure The Cross Pieces Were Evenly Spaced From The Top And Bottom.
They are not just easy to make but also require minimal tools and materials. Follow along and learn how to build it yourself!get the f. Nail gun and nails (1 1/4″, 18 gauge finish nails) tape measure.
After Cutting The Batten To Length And Chamfering Its Edges, I Measured 6” From The End Of The Shutter, Added Glue To The Back Of The Batten Where It Comes In Contact With The Boards, And Set The Bottom Of The Batten On The 6” Mark.
Every pile of six was to make two shutters for either side of each window. Paint sticks as spacers and scrap wood as a guide while gluing and nailing the cross pieces on. Using pine, you can get the cost down to about $18.00 per pair.
I Also Flipped The Boards Over And Screwed The Cross Pieces In From The Back For Durability Using 1 1/4″ Screws And My Drill.
This will give you a couple extra just in case! Just take a look bellow, and start working! It’s not hard, we promise.
In This Video I'll Walk You Through A Simple Way To Make Your Own Board And Batten Shutters With Minimal Woodworking Tools.
If your windows are quite tall, then you might consider using an extra batten in the middle and make the boards longer. Paint sticks to use as spacers between boards. I clamped it in place while driving 2 1/2” wood screws from the back of the board into the batten.
Adding Shutters Made Our House A Little More Polished And Cozy.
Install the screws that hold it into place. Nails wood glue miter saw (or get them cut at your local home improvement store) decorative plastic hinges Two 6″ pieces of scrap wood were used as a guide to make sure the cross pieces were evenly spaced from the top and bottom.
